This economical fitting resists mechanical pull-out. Can be assembled and disassembled repeatedly.
Standard fittings use short nuts. long nuts are used when greater vibration is required
Meets functional requirements of SAE J512 and J513.
Tube O.D. | 1/8 | 3/16 | 1/4 | 5/16 | 3/8 | 7/16 | 1/2 | 5/8 | 3/4 | 7/8 | 1 |
Thread Size-B | 5/16-24 | 3/8-24 | 7/16-20 | 1/2-20 | 5/8-18 | 11/16-16 | 3/4-16 | 7/8-14 | 1 1/16-14 | 1 1/4-12 | 1 3/8-12 |
Use with copper, brass, aluminium and welded steel hydraulic tubing that can be flared. Manufactured especially for hard-to-hold liquids and gases.
Temperature and type of tubing used are important factors. Following table is a goodguide for proper selection. Temperature 730F with copper tubing:
PSI | Tube O.D.(Inches) | Tube Wall (Inches) |
2800 | 1/8 | 0.030 |
1900 | 3/16 | 0.030 |
1400 | 1/4 | 0.030 |
1200 | 5/16 | 0.032 |
1000 | 3/8 | 0.032 |
750 | 1/2 | 0.032 |
650 | 5/8 | 0.035 |
550 | 3/4 | 0.035 |
450 | 7/8 | 0.035 |
Resists mechanical pull-out.
Easy to Disassemble and can be reassembled many times, with no effect on the seal.
From -65o to +250oF